Hyundai Azera: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
35R Clutch Control Solenoid Valve(35R/C_VFS) Schematic Diagrams
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description and OperationRear Oil Seal Repair procedures
Removal
1.
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate")
2.
Remove the rear oil seal (A).
Installation
1.
Using SST(09231-3C200, 09231-H1100), install the rear oil s ...
Changing the engine oil and filter
Have engine oil and filter changed by an authorized HYUNDAI dealer according
to the Maintenance Schedule at the beginning of this section.
WARNING - California proposition 65
Engine oil contains ch ...
Removable towing hook (front, if equipped)
1. Open the trunk, and remove the towing hook from the tool case.
2. Remove the hole cover pressing the lower part of the cover on the front bumper.
3. Install the towing hook by turning it clockw ...