Using the blows power of FAN on seat, remove the moisture, sweat and warmth from occupants and surface of seats.
It inhales the indoor air through the blower installed at the
seat cushion lower part, and supplies the air into the seat cushion and
the seat back through the duct.
It sends a slight air throughout the seat surface through the air channel set up at seat cushion and seat back.
| 1. |
Make sure not to spoil drink or water on the seat when equipping with ventilation system seat |
| 2. |
Because of inhaling the slight air, it is difficult to feel the air strength by the sense of touch. |
|
Removal
[Front Seat]
1.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
2.
Remove the seat back cover and cushion cover.
(Refer to Body - "Front Seat Cushion Cover") ...
See also:
26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Mode Control Actuator Repair procedures
Inspection
1.
Ignition "OFF”
2.
Disconnect the connector of mode control actuator.
3.
Verify that the mode control actuator operates to the defrost
mode when connecting 12V to the term ...
Consumer information
This consumer information has been prepared in accordance with regulations issued
by the National Highway Traffic Safety Administration of the U.S. Department of
Transportation.
Your Hyundai dealer ...