Hyundai Azera: Anchor Pretensioner (APT) Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
| 2. |
To remove the seat belt anchor pretensioner (C), keep on
pushing the lock pin (A) as arrow direction. And then remove the seat
belt after pushing the lock pin (B).
|
| 3. |
Remove the door scuff trim.
|
| 4. |
Remove the center pillar trim.
|
| 5. |
Disconnect the anchor pretensioner connector (A).
|
| 6. |
Loosen the anchor pretensioner mounting bolt (B) and remove the anchor pretensioner. |
| Installation |
| 1. |
Remove ignition key from the vehicle. |
| 2. |
Disconnect the negative (-) cable from battery and wait for at least three minutes. |
| 3. |
Install the anchor pretensioner with a bolt.
|
| 4. |
Connect the anchor pretensioner connector. |
| 5. |
Install the center pillar trim.
|
| 6. |
Install the door scuff trim.
|
| 7. |
Insert the seat belt to the anchor pretensioner (A).
|
| 8. |
Reconnect the battery negative cable. |
| 9. |
After installing the anchor pretensioner, confirm proper system operation:
|
Anchor Pretensioner (APT) Components and Components Location
Brake SystemEngine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [ELG-A]
Pin No.DescriptionConnected to1-?2-?3-?4Immobilizer Lamp control outputImmobilizer Lamp [Without Button Engine Sta ...
Rear Pillar Trim Components and Components Location
Component Location
1. Rear pillar trim
...
Maintenance under severe usage conditions
The following items must be serviced more frequently on cars normally used under
severe driving conditions. Refer to the chart below for the appropriate maintenance
intervals. R : Replace I : Inspec ...