Hyundai Equus Manuals

Hyundai Azera: Barometric Pressure Sensor (BPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Barometric Pressure Sensor (BPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.

Specification: Refer to "Specification"

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the barometric pressure sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor from the air cleaner assembly.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Installation is reverse of removal.

Barometric pressure sensor installation bolt:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Barometric Pressure Sensor (BPS) Schematic Diagrams
Circuit Diagram ...

Intake Air Temperature Sensor (IATS) Description and Operation
Description Intake Air Temperature Sensor (IATS) is included inside Barometric Pressure Sensor (BPS) and detects the intake air temperature. To calculate precise air quantity, correction of the ai ...

See also:

Heated Oxygen Sensor (HO2S) Troubleshooting
Wave Form ...

SS-B Solenoid Valve(ON/OFF) Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ? Control type : Normal low type Control pressure [kpa (kgf/cm?, psi)]490.33(5.0, 71.12) Internal resistance(?)10~11 ...

TJ Joint Repair procedures
Replacement     • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a ne ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com