Your vehicle has a maintenance-free, calcium-based battery.
- If the battery becomes discharged in a short time (because, for example,
the headlights or interior lights were left on while the vehicle was not in
use), recharge it by slow charging (trickle) for 10 hours.
- If the battery gradually discharges because of high electric load while
the vehicle is being used, recharge it at 20-30A for two hours.
When recharging the battery, observe the following precautions:
- The battery must be removed from the vehicle and placed in an area with
good ventilation.
- Watch the battery during charging, and stop or reduce the charging rate
if the battery cells begin gassing (boiling) violently or if the temperature
of the electrolyte of any cell exceeds 120°F (49°C).
- Wear eye protection when checking the battery during charging.
- Disconnect the battery charger in the following order.
1. Turn off the battery charger main switch.
2. Unhook the negative clamp from the negative battery terminal.
3. Unhook the positive clamp from the positive battery terminal.
- Before performing maintenance or recharging the battery, turn off all accessories
and stop the engine.
- The negative battery cable must be removed first and installed last when
the battery is disconnected.
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections clean, tight, and coated with petroleum
jelly or terminal grease.
Rinse any spilled ...
Items should be reset after the battery has been discharged or the battery has
been disconnected.
Auto up/down window (See section 4)
Sunroof (See section 4)
Driver position memory system (Se ...
See also:
SCAN
Press the key to scan all channels
with superior reception for 5 seconds each.
Once scan is complete, the previously played channel will be restored.
During Scan, pressing the key again
will can ...
Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary.
Also check all ignition wiring and components to be sure they are not cracked, worn
or damaged in any way. ...
Knock Sensor (KS) Description and Operation
Description
Knocking is a phenomenon characterized by undesirable
vibration and noise and can cause engine damage. The two Knock Sensor
(KS) are installed inside the V-valley of the cylinder bl ...