Inspection |
1. |
Ignition "OFF". |
2. |
Disconnect evaporator temperature sensor. |
3. |
Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification
|
Replacement |
1. |
Remove the console extension cover (A). |
2. |
Remove the crash pad lower cover (A) and then disconnect the connector (B). |
3. |
Remove the cooling hose. |
4. |
Disconnect the evaporator temp connector (A). |
5. |
Remove the evaporator temperature sensor (A), by pulling it after rotating 90° in a counterclockwise direction. |
6. |
Installation is the reverse order of removal. |
Barometric Pressure Sensor (BPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Turn ...
Rear Disc Brake Components and Components Location
Components
1. Guide rod bolt2. Bleed screw3. Caliper carrier4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer
...
Refrigerant label (If equipped)
The refrigerant label is located on the underside of the hood.
The label contains the following information:
Type of refrigerant
Amount of refrigerant
...