Hyundai Equus Manuals

Hyundai Azera: Front Bumper Cover Repair procedures - Front Bumper - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Bumper Cover Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
After loosening the mounting bolts and clips, then remove the radiator grill side cover (A).

2.
Loosen the radiator grill upper cover mounting bolts and clips.

3.
After loosening the front bumper side mounting screw, disconnect the side.

4.
Remove the front bumper lower mounting clips.

5.
Remove the front bumper cover.
6.
Disconnect the fog lamp connector (A) and connector (B).
[LH]

[RH]

7.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
•
Make sure the connector is plugged in properly.
Front Bumper Cover Components and Components Location
Component Location 1. Front bumper cover ...

Rear Bumper
...

See also:

Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DON'T remove the camshaft posit ...

Rear Upper Arm Repair procedures
Removal 1. Remove the rear wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolts when ...

Instrument panel illumination
The instrument panel illumination intensity can be adjusted as follows: Ignition switch in the ON position Pushing the control switch up or down The illumination intensity is shown on the ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com