Replacement |
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Remove the front door window glass mounting hole plug (B).
|
3. |
Carefully adjust the front door window glass (A) until you
can see the bolts, then loosen them. Separate the glass from the glass
run and carefully pull the glass out through the window slot.
|
4. |
Installation is the reverse of removal.
|
On-board Refueling Vapor Recovery (ORVR) valve Repair procedures
Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel tank.
(Refer to Fuel System - "Fuel Tank")
3.
Disconnect the vapor hose (A).
4.
Remove ...
Injector Drive Box (IDB) Schematic Diagrams
IDB terminal and Inoutput
IDB terminal function
Connector [CLG02]
Pin No.DescriptionConnected to1-?2-?3-?4-?5-?6-?7-?8-?9-?10-?11-?12-?13-?14-?15-?16Injector (Cylinder #3) [Low] control outputI ...
Outside Rear View Mirror Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...