Replacement |
1. |
Detach the clips, then remove the hood seal weatherstrip (A).
|
2. |
Installation is the reverse of removal.
|
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
Components and Components Location
Component Location
1. Cluster assembly2. Seat belt switch3. Vehicle speed sensor4. Water temperature gauge sender5. Oil pressure switch6. Brake oil level switch7. Parking brake switch8. Door swit ...
Rear Curtain Repair procedures
Inspection
Connect the battery voltage and check the rear curtain motor
rotation. If the motor does not operate properly, substitute with a
known-good rear curtain motor and check for proper op ...