Hyundai Azera: Side Sill Molding Repair procedures
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Body Side Molding / Side Sill Molding Repair procedures
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Body Side Molding / Side Sill Molding Repair procedures
| Replacement |
|
| 1. |
Loosen the mounting screws. |
| 2. |
Using a screwdriver or remover, remove the side sill molding (A). |
| 3. |
Installation is the reverse of removal.
|
Waist Line Molding Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
Panoramaroof
...
See also:
Transaxle Control Module (TCM) Schematic Diagrams
TCM connector and terminal function
TCM Terminal Function
Connector [ELG-A]
PinDescriptionPinDescription1?51?2?52?3?53?4?54Sports mode down switch5?55?6?56?7?57?8?58?9CCP CAN(HIGH)59?10CAN Commu ...
Blower Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower unit.
(Refer to Heater - "Heater Unit")
3.
Remove the blower unit (A) from the heater unit ...
Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary.
Also check all ignition wiring and components to be sure they are not cracked, worn
or damaged in any way. ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com