Hyundai Equus Manuals

Hyundai Azera: Front Seat Back Cover Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Seat Back Cover Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Back Cover Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
3.
Push the lock pin (B), remove the front seat headrest (A).

4.
Remove the protector (A).

5.
Disconnect the front seat heater connector (A).

6.
Push the clips (B) from the front seat back board (A).
   
•
Push the middle area of clip using the flat head screwdriver.
•
Be careful not to damage the clip.

7.
After loosening the mounting screws, then remove the air ventilation seat duct (A).

8.
Push the protecter (A) by the front seat back frame.

9.
Pull out the headrest guides (A) while pinching the end of the guides, and remove them.

10.
Remove the front seat back cover (A) from the front seat frame.

11.
After removing the velcro tape (A) on the front of seat back and remove the front seat back cover (B).

12.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
Front Seat Back Cover Components and Components Location
Component Location 1. Front seat back cover ...

Front Seat Cushion Cover Components and Components Location
Component Location 1. Front seat cushion cover ...

See also:

Speakers Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector ...

Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed in ...

Center Fascia Panel Components and Components Location
Component Location 1. Center fascia panel ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com