Hyundai Equus Manuals

Hyundai Azera: Rear Back Armrest Cup Holder Repair procedures - Rear Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Back Armrest Cup Holder Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Back Armrest Cup Holder Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Remove the rear back armrest.
(Refer to Rear Seat - "Rear Back Armrest")
2.
Using a screwdriver or remover, remove the rear seat back armrest inner cover (A).

3.
Disconnect the connector (A).

4.
Using a screwdriver or remover, remove the rear seat armrest remote controll (A).

5.
Disconnect the connectors (A).

6.
After loosening the mounting screws, then remove the rear back armrest cup holder (A).

7.
Installation is the reverse of removal.
   
•
Make sure the connectors are plugged in properly.
•
Replace any damage clips.
Rear Back Armrest Cup Holder Components and Components Location
Component Location 1. Rear back armrest cup holder ...

Front Seat Belt
...

See also:

Engine Cover Components and Components Location
Components Location 1. Engine cover ...

Rear Door Latch Components and Components Location
Component Location 1. Rear door latch ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Specifications Direct control VFS[OD/C] ? Control type : Normal low type Control Pressure [kpa (kgf/cm?, psi)]500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50~850 Internal resis ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com