Inspection |
1. |
Ignition "OFF". |
2. |
Disconnect evaporator temperature sensor. |
3. |
Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor.
Specification
|
Replacement |
1. |
Remove the console extension cover (A). |
2. |
Remove the crash pad lower cover (A) and then disconnect the connector (B). |
3. |
Remove the cooling hose. |
4. |
Disconnect the evaporator temp connector (A). |
5. |
Remove the evaporator temperature sensor (A), by pulling it after rotating 90° in a counterclockwise direction. |
6. |
Installation is the reverse order of removal. |
Components and Components Location
Components (1)
1. Parking brake pedal2. Parking brake cable3. Equalizer assembly
Components (2)
1. Backing plate2. Operating lever3. Upper spring4. Lower spring5. Adjuster6. Shoe hold down ...
Rear Curtain Repair procedures
Inspection
Connect the battery voltage and check the rear curtain motor
rotation. If the motor does not operate properly, substitute with a
known-good rear curtain motor and check for proper op ...
Battery Repair procedures
Removal and Installation
1.
Remove the air duct (B).
2.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)
3.
D ...