Hyundai Equus Manuals

Hyundai Azera: In-car sensor Repair procedures - Air Conditioning System - Heating,Ventilation, Air Conditioning - Hyundai Azera 2011-2024 Service ManualHyundai Azera: In-car sensor Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / In-car sensor Repair procedures

Inspection
1.
Ignition "ON"
2.
Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals.

1. Incar Motor(-)
2. Sensor GND
3. -
4. Incar Sensor (+)
5. -
6. IGN2 (Incar Motor (+))

Temperature [°C(°F)]
Resistance between terminals 2 and 4 (k?)
60(140)
7.463 ± 2.6%
50(122)
10.810 ± 2.2%
35(95)
19.59 ± 1.6%
25(77)
30.00 ± 1.2%
15(59)
47.130 ± 1.7%
0(32)
97.710 ± 2.4%
-15(5)
216.1 ± 3.2%
-30(-22)
509.6 ± 4.1%

   
In car sensor is negative type thermistor that resistance will rise with lower temperature, and reduce with higher temperature.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lower crash pad.
3.
Disconnect the connector of in-car sensor.
Loosen the mounting 2 screws and then remove the in-car sensor (B).

4.
installation is the reverse order of removal.
In-car sensor Description and Operation
Description 1. In-car air temperature sensor is located at the lower crash pad. 2. The sensor contains a thermistor which measures the temperature of the cabin. The signal, determined by the ...

Photo Sensor Description and Operation
Description 1. The photo sensor is located at the center of defrost nozzle. 2. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its lig ...

See also:

Injector Drive Box (IDB) Schematic Diagrams
IDB terminal and Inoutput IDB terminal function Connector [CLG02] Pin No.DescriptionConnected to1-?2-?3-?4-?5-?6-?7-?8-?9-?10-?11-?12-?13-?14-?15-?16Injector (Cylinder #3) [Low] control outputI ...

SRS Control Module (SRSCM) Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. (Ref ...

Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn si ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com