Hyundai Equus Manuals

Hyundai Azera: Cylinder Block Components and Components Location - Cylinder Block - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Cylinder Block Components and Components Location

Components

1. Piston ring
2. Piston
3. Connecting rod
4. Connecting rod upper bearing
5. Piston pin
6. Connecting rod lower bearing
7. Connecting rod bearing cap
8. Baffle plate
9. Upper oil pan
10. Cylinder block
11. Snap ring
12. Water jacket separator

1. Oil drain cover
2. Oil drain cover gasket
3. Crank shaft upper bearing
4. Thrust bearing
5. Adapter plate
6. Drive plate
7. Rear oil seal
8. Rear oil seal case
9. Crankshaft
10. Crankshaft lower bearing
11. Main bearing cap
12. Oil cover
13. Oil cover gasket

Rear Oil Seal Repair procedures
Removal 1. Remove the drive plate. (Refer to Cylinder Block - "Drive Plate") 2. Remove the rear oil seal (A). Installation 1. Using SST(09231-3C200, 09231-H1100), install the rear oil s ...

Cylinder Block Repair procedures
Disassembly     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Troubleshooting
Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. ...

Special Service Tools
Special Service Tools Tools(Number and name)IllustrationUse09200-38001, 09200-3N000Engine support fixture (Beam)Removal and installation of the transaxle.Except lower supporter, use beam only w ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com