Hyundai Equus Manuals

Hyundai Azera: Water pump Repair procedures - Cooling System - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Water pump Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Water pump Repair procedures

Removal
1.
Drain the coolant.
(Refer to Cooling System - "Coolant")
2.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
3.
Remove the water pump pulley (A).

4.
Remove the water pump (A) and gaskets (B).

Installation
Water Pump
1.
Install the water pump (A) with the new gaskets (B).

   
•
Clean the contact face before assemble.
•
Always use a new gaskets.
Tightening torque
A(3EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
B(1EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
C(1EA): 21.6 ~ 26.5N.m (2.2 ~ 2.7kgf.m, 15.9 ~ 19.5lb-ft)
D(1EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
E(1EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
F(1EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
G(4EA) :21.6 ~ 23.5N.m (2.2 ~ 2.4kgf.m, 15.9 ~ 17.4lb-ft)

2.
Install the water pump pulley (A).
Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)

3.
Install the drive belt.
(Refer to Timing System - "Drive Belt")
4.
Fill the radiator with coolant and check for leaks.
Water pump Components and Components Location
Components 1. Water pump pulley2. Water pump 3. Water pump gasket ...

Water pump Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If cool ...

See also:

Rear Door Latch Components and Components Location
Component Location 1. Rear door latch ...

Body Control Module (BCM) Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the Reinforcing panel after loosening the ...

Knock Sensor (KS) Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. The two Knock Sensor (KS) are installed inside the V-valley of the cylinder bl ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com