Accelerator Position Sensor (APS) is installed on the
accelerator pedal module and detects the rotation angle of the
accelerator pedal. The APS is one of the most important sensors in
engine control system, so it consists of the two sensors which adapt
individual sensor power and ground line. The second sensor monitors the
first sensor and its output voltage is half of the first one. If the
ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the
diagnostic system judges that it is abnormal.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector.
3.
Remove the OTS. (Refer to "Removal")
4.
After immersing the thermistor of the sensor into engine coolant ...
Specification
AcceleratorPositionOutput Voltage (V)APS1APS2C.T0.7 ~ 0.80.29 ~ 0.46W.O.T3.85 ~ 4.351.93 ~ 2.18
...
See also:
Components and Components Location
Components
1. LDWS ON/OFF switch2. Instrument cluster3. LDWS unit
...
Connecting a Device
Press the key
Select [Phone]
Select [Paired Phone List]
1) Connected Phone : Device that is currently connected
2) Paired Phone : Device that is paired but not connected
From the ...
IMS (Integrated Memory System) module Repair procedures
Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the driver seat in the car.
(Refer to Body - "Front Seat Assembly")
3.
Remove the IMS module (A) after loosening 3 screws in ...