Hyundai Equus Manuals

Hyundai Azera: Fuel Tank Pressure Sensor (FTPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.

Specification: Refer to "Specification"

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the floor mat in the trunk.
3.
Remove the service cover (A).

4.
Disconnect the fuel tank pressure sensor connector (A).
5.
Remove the fuel tank pressure sensor (A) after releasing the hooks veritically.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Installation is reverse of removal.
Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram ...

Injector Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is cont ...

See also:

Change to "winter weight" oil if necessary
In some climates it is recommended that a lower viscosity "winter weight" oil be used during cold weather. See section 8 for recommendations. If you aren't sure what weight oil you sho ...

Main Crash Pad Assembly Repair procedures
Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com