Hyundai Azera: 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
26 Brake Control Solenoid Valve(26/B_VFS) Schematic Diagrams
Line Pressure Control Solenoid Valve Description and OperationTroubleshooting
Troubleshooting
SymptomSuspect AreaRemedy (Refer to page)Water leaks from sunroofDeteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance and improperly fitted weatherstripAd ...
SS-B Solenoid Valve(ON/OFF) Schematic Diagrams
Circuit Diagram
...
TPMS (Tire Pressure Monitoring System) malfunction indicator
The TPMS malfunction indicator will illuminate after it blinks for approximately
one minute when there is a problem with the Tire Pressure Monitoring System. If
the system is able to correctly det ...