Hyundai Azera: Hood Latch Release Handle Components and Components Location

Hood Weatherstrip Repair procedures

Replacement 1. Remove the hood weatherstrip (A). 2. Installation is the reverse of removal. ...

Hood Latch Release Handle Repair procedures

Replacement 1. Using a screwdriver or remover, remove the hood release handle (A).     • Use a 6mm hex bit to press the center until the handle easily pulls off the post. ...

See also:

Buzzer Repair procedures
Removal Buzzer 1. Disconnect the negative(-) battery terminal. 2. Remove the front left wheel guard. 3. Remove the external buzzer (A) after disconnecting the connector. Installation ...

Dynamic Damper Components and Components Location
Components 1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circlip ...

Wheel Repair procedures
Lug nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, final tigh ...