Hyundai Azera: Horn

Repair procedures

Inspection (With GDS) 1. Check BCM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. 2. If diagnosis is ...

Components and Components Location

Component Location 1. Horn switch2. Horn relay (Engine room compartment)3. Horn - High pitch4. Horn - Low pitch5. Clock spring ...

See also:

Idler Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the drive belt idler (A). Tightening torque : 52.9 ~ 57.9N.m (5.4 ~ 5.9kgf.m, 39.1 ~ ...

Rear Oil Seal Repair procedures
Removal 1. Remove the drive plate. (Refer to Cylinder Block - "Drive Plate") 2. Remove the rear oil seal (A). Installation 1. Using SST(09231-3C200, 09231-H1100), install the rear oil s ...

Exhaust pipe and muffler
Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration, or damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten connections or replace parts ...