Removal |
1. |
Remove the negative (-) battery terminal. |
2. |
Remove the driver seat in the car.
|
3. |
Remove the IMS module (A) after loosening 3 screws in the bottom of seat. |
4. |
Disconnect the IMS module connector (A) and then remove the IMS module (B). |
Installation |
1. |
Install the IMS module after reconnecting the connector. |
2. |
Install the driver seat.
|
Operation of the rear parking assist system
Operating condition
This system will activate when backing up with the ignition switch ON.
The sensing distance while the rear parking assist system is in operation
is approximately 47 in. (12 ...
Smart Cruise Control Switch Repair procedures
Removal and Installation
1.
Disconnect the negative battery cable.
2.
Disconnect the driver air bag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Remove ...
Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots
of trees. Become familiar with the off-road conditions where you are going to drive
before you begin driving. ...