Hyundai Equus Manuals

Hyundai Azera: Injector Drive Box (IDB) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Injector Drive Box (IDB) Repair procedures

Removal
1.
Turn the ignition switch off and disconnect the battery negative (-) cable.
2.
Disconnect the injector drive box (IDB) connector (A).

3.
Remove the air cleaner assembly.
4.
Remove the main wiring harness (B) after removing the nut (A).

5.
Remove the IDB bracket assembly (B) after removing the bolts (A).

6.
After removing the installation bolts (A), remove the IDB from the bracket.

Installation
1.
Installation is the reverse of removal.

IDB installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
IDB bracket installation bolt (on vehicle):
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Injector Drive Box (IDB) Schematic Diagrams
IDB terminal and Inoutput IDB terminal function Connector [CLG02] Pin No.DescriptionConnected to1-?2-?3-?4-?5-?6-?7-?8-?9-?10-?11-?12-?13-?14-?15-?16Injector (Cylinder #3) [Low] control outputI ...

ETC (Electronic Throttle Control) System Description and Operation
Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cab ...

See also:

Rail Pressure Sensor (RPS) Schematic Diagrams
Circuit Diagram ...

Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ConditionOutput Voltage (V)IG ONApprox. 4.44VIdleApprox. 0.75V ...

In-car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals. 1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com