Replacement |
|
1. |
Using a screwdriver or remover, remove the front frame inner cover (A). |
2. |
Disconnect the outside rear view mirror connector (A). |
3. |
After loosening the mounting nuts, then remove the outside rear view mirror (B).
|
4. |
Installation is the reverse of removal.
|
Heater & A/C Control Unit(Full Automatic) Components and Components Location
Components
Connector pin function
ConnectorPIN NoFunctionConnectorPIN NoFunctionConnector (A)1Tail (+)Connector (A)27Evaporator Sensor (+)2Sensor REF (+5V)28-3CAN HIGH29Incar Sensor (+)4CAN LOW30D ...
TPMS Sensor Description and Operation
Description
1.
Mode
(1)
Configuration State
A.
All sensors should be in the Low Line state.
B.
In High Line configuration, sensor transmissions occur every 1 minute (nominal) and pressure ...
Intake Air Temperature Sensor (IATS) Description and Operation
Description
Intake Air Temperature Sensor (IATS) is included inside Barometric Pressure Sensor (BPS) and detects the intake air temperature.
To calculate precise air quantity, correction of the ai ...