Hyundai Equus Manuals

Hyundai Azera: Purge Control Solenoid Valve (PCSV) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Purge Control Solenoid Valve (PCSV) Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hoses (B) from the purge control solenoid valve.
4.
Remove the valve from the bracket.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Be sure not to apply oil or lubricant to the end of the hoses when connecting the PCSV hose.
   
•
Be careful of foreign material not to flow into the valve.
1.
Installation is reverse of removal.
Purge control solenoid valve bracket installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m 7.2 ~ 8.7 lb-ft)
Purge Control Solenoid Valve (PCSV) Schematic Diagrams
Circuit Diagram ...

CVVT Oil Control Valve (OCV) Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

See also:

Digital clock (if equipped)
WARNING Do not adjust the clock while driving. You may lose your steering control and cause an accident that results in severe personal injury or death. Whenever the battery terminals or relate ...

Rear Shock Absorber Repair procedures
Replacement 1. Remove the rear wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolts w ...

Valve Body Repair procedures
Removal 1. Remove the battery and the battery tray. (Refer to Engine Electrical System - "Battery") 2. Remove the under cover (A). Tightening torque: 7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com