Hyundai Azera: Rail Pressure Sensor (RPS) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
| Description |
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in the sensor converts the
pressure to voltage signal. By using this signal, the ECM can control
correct injection amount and timing and adjusts the fuel pressure with
the fuel pressure regulator valve if the target pressure and the actual
pressure calculated by the RPS output signal are different.
Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Rail Pressure Sensor (RPS) Specifications
Specification
...
See also:
Cooling Fan Components and Components Location
Components
1. Cooling fan2. Fan motor3. Fan shroud
...
Passive Occupant Detection System (PODS-F) Components and Components Location
Components
...
Fuel Tank Repair procedures
Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
2.
Remove the fuel pump service cover (A) in the trunk.
...
Categories
Hyundai Azera Manuals
2011-2026 Copyright www.hgmanual.com