Hyundai Azera: Rain Sensor Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Windshield Wiper/Washer / Rain Sensor Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Windshield Wiper/Washer / Rain Sensor Description and Operation
| Description |
The Rain sensing windshield wiper system is a wiper system
that, in addition to providing normal wiper functions off, mist, manual
low speed, manual high speed, and wash, provides automatic control of
automatic intermittent automatic low, and automatic high speeds.
When the ignition key is in the ON position, the rain sensor (A) will be activated.
| System Function |
Basic Principle
Emitted Beam from luminosity diode is reflected entirely against the windshield exterior, and then turn into photo diode.
If there is water on the windshield exterior, beam separates
optically, and the degree of remained beam is measured in the photo
diode.
What there is water in the windshield, it means beam is not
reflected all, so the degree of lost beam indicates the degree of glass
surface wet.
Rainsensor consist of two luminosity diode, two photo diode, optic fiber and coupling pad. |
Operation Control
Wiper ECU transmits the signal as a rainsesor, and then the
rainsensor perceives the rainwater to transmit to the wiping order wiper
ECU, wiper ECU controls the wiper motor according to the signal.
Contact Influence
The rainsensor can malfunction due to following condition
| • |
Contamination of the measurement surface. |
| • |
Air bubbles between the windshield and the coupling pad contact surface. |
| • |
The movement of coupling pad by vibration. |
| • |
Damaged wiper blade. |
Operation Condition
In case that engine starts under wiper switch AUTO,
rainsensor activates after once wiper operation to inform the driver
that the system is under AUTO.
In case that the rainsensor doesn't work or malfunction, the driver can operate the wiper switch manually. |
Rain Sensor Schematic Diagrams
Circuit Diagram
...
Rain Sensor Repair procedures
Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are
controlled by the rain sensor inpu ...
See also:
Starter Relay Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalContinuity30 - 87NO85 - 86Y ...
Components and Components Location
Components
1. HECU module2. Front wheel speed sensor3. Rear wheel speed sensor4. Yaw rate & Lateral G sensor5. Steering angle sensor6. ABS Warning lamp7. Parking brake/EBD warning lamp8. ESC ...
Blower Motor Repair procedures
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for prop ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com