Hyundai Azera: Rear Combination Lamp Repair procedures
| Rear Combination Lamp (Outside) |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A).
|
| 3. |
Remove the nuts (4EA).
|
| 4. |
Remove the rear combination lamp (A) after disconnecting the connector.
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
If the bulbs should be only replaced without removing lamp
assembly, replace the back up lamp bulb (A) after removing the trim
cover in the trunk.
|
| 3. |
Remove the rear garnish assembly (A).
|
| Installation |
| 1. |
Install the rear combination lamp assembly after assembling the bulb. |
High Mounted stop lamp Repair procedures
Turn Signal Lamp Repair proceduresBattery saver function
The purpose of this feature is to prevent the battery from being discharged.
The system automatically turns off the parking lights when the driver turns
off the engine and opens the driver-side ...
Overhead Console Lamp Repair procedures
Inspection
Overhead Console Lamp
Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
...
Water Jacket Seperator Components and Components Location
Components
1. Water jacket separator
...