Inspection |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear package tray (A) after removing the rear seat.
|
3. |
Remove the rear curtain (A) after removing the connector and bolts (6EA). |
4. |
If necessary of removing the rear curtain motor (A), remove the screws (3EA). |
Installation |
1. |
Install the rear curtain and connector. |
2. |
Install the rear package tray and rear seat. |
3. |
Connect the negative (-) battery terminal. |
Rear Door Latch Repair procedures
Replacement
1.
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module")
2.
Disconnect the rear door latch connector (A).
3.
Remove the rear door latch assembly (A).
4.
I ...
Transaxle Oil Temperature Sensor Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Water Pipe Components and Components Location
Components
1. Water center pipe2. O-ring
...