Hyundai Equus Manuals

Hyundai Azera: Rear Seat Back Cover Repair procedures - Rear Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Seat Back Cover Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Back Cover Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Disconnect the connectors (A), and mounting wireing clips (B).

3.
After loosening the mounting screws, then remove the rear back armrest board (A).

4.
After loosening the mounting bolts, then remove the rear back armrest (A).

5.
Push the lock pin (B), remove the headrest (A).

6.
After loosening the mounting screws, then remove the rear seat back webbing guide (A).

7.
Pull out the headrest guides (A) while pinching the end of the guides, and remove them.

8.
Remove the hog-ring clips (A).

9.
After removing the velcro tape (A) and hog-ring clips (B) on the rear of seat back and remove the rear seat back cover (C).

10.
Installation is the reverse of removal.
   
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool [C (09880-4F000)].

Rear Seat Back Cover Components and Components Location
Component Location 1. Rear seat back cover ...

Rear Seat Cushion Cover Components and Components Location
Component Location 1. Rear seat cushion cover ...

See also:

Owner maintenance schedule
When you stop for fuel: Check the engine oil level. Check coolant level in coolant reservoir. Check the windshield washer fluid level. Look for low or under-inflated tires. Check the radia ...

Output Speed Sensor Description and Operation
Description The output speed sensor is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the Transaxle Control Modu ...

Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 7,500 miles (12,000 km) or sooner if irregular wear develops. During rotation, check the tires for correct balance. When ro ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com