Hyundai Azera: Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Fender / Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Fender / Repair procedures
| Replacement |
|
| 1. |
Remove the head lamps.
|
| 2. |
Loosen the mud guard mounting screws.
|
| 3. |
After loosening the mounting screws and clips, then remove the side sill molding (A).
|
| 4. |
Using a screwdriver or remover, remove the fender garnish (A).
|
| 5. |
Detach the clips and then remove the fender side cover (A).
|
| 6. |
Using a screwdriver or remover, remove the delta garnish (A).
|
| 7. |
After loosening the mounting screws and bolt, then remove the front bumper side mounting bracket (A).
|
| 8. |
After loosening the fender mounting bolts and nut, then remove the fender (A).
|
| 9. |
Installation is the reverse of removal. |
Components and Components Location
Component Location
1. Fender
...
Hood
...
See also:
Starter Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
3.
Remove the starter cover (A).
Tightening torque :
Bolts: 8.8 ~ 13.7 N. ...
Inside Rear View Mirror Repair procedures
Replacement
[ECM Mirror]
1.
Remove the ECM mirror cover (A).
2.
Disconnect the ECM mirror connector (B).
3.
Loosen the ECM mirror mounting screw (A).
4.
Push the ECM mirror base up to ...
Engine overheat
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine is probably too hot. If this happens,
you should:
1. Pull off the road ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com