Removal and Installation |
1. |
Disconnect the over flow hose (A), and then remove the resorvior tank (B).
|
2. |
Installation is in the reverse order of removal. |
3. |
Fill the reservoir tank to the "F" line with coolant. |
TJ Joint Components and Components Location
Components
[LH]
1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circl ...
Cruise Control Switch Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the steering wheel.
(Refer to Steering ...
Side Sill Molding Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...