Hyundai Equus Manuals

Hyundai Azera: Water pump Repair procedures - Cooling System - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Water pump Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Water pump Repair procedures

Removal
1.
Drain the coolant.
(Refer to Cooling System - "Coolant")
2.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
3.
Remove the water pump pulley (A).

4.
Remove the water pump (A) and gaskets (B).

Installation
Water Pump
1.
Install the water pump (A) with the new gaskets (B).

   
•
Clean the contact face before assemble.
•
Always use a new gaskets.
Tightening torque
A(3EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
B(1EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
C(1EA): 21.6 ~ 26.5N.m (2.2 ~ 2.7kgf.m, 15.9 ~ 19.5lb-ft)
D(1EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
E(1EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
F(1EA): 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
G(4EA) :21.6 ~ 23.5N.m (2.2 ~ 2.4kgf.m, 15.9 ~ 17.4lb-ft)

2.
Install the water pump pulley (A).
Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)

3.
Install the drive belt.
(Refer to Timing System - "Drive Belt")
4.
Fill the radiator with coolant and check for leaks.
Water pump Components and Components Location
Components 1. Water pump pulley2. Water pump 3. Water pump gasket ...

Water pump Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If cool ...

See also:

Crash Pad Side Cover Repair procedures
Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

TPMS Receiver Description and Operation
Description 1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. B. In this state, there is no Auto-L ...

Master Cylinder Repair procedures
Removal 1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air duct (B) and air cleaner assembly (A). 3. Disconnect the brake fluid level switch conne ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com