Inspection |
1. |
Remove the cowl top cover.
(Refer to Windshield Wiper/Washer - "Front Wiper Motor") |
2. |
Disconnect the windshield deicer connector from the wiper motor linkage. |
3. |
Check for continuity between the terminals of deicer lines. |
4. |
Turn the ignition switch ON and the windshield deicer switch
ON, then measure the voltage between the terminals of harness side
deicer connector.
|
Reservoir Tank Components and Components Location
Components
1. Reservoir tank2. Over flow hose
...
Water pump Components and Components Location
Components
1. Water pump pulley2. Water pump 3. Water pump gasket
...
Input Speed Sensor Troubleshooting
Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...