Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Crash Pad Side Cover Components and Components Location
Component Location
[LH]
1. Crash pad side cover [LH]
[RH]
1. Crash pad side cover [RH]
...
Timing Chain Repair procedures
Removal
1.
Set No.1 cylinder to TDC/compression.
(1)
Turn the crankshaft pulley clockwise and align its groove with the timing mark "T" of the lower timing chain cover.
(2)
Check that the m ...
SS-B Solenoid Valve(ON/OFF) Specifications
Specifications
ON/OFF Solenoid Valve(SS-A, SS-B)
? Control type : Normal low type
Control pressure [kpa (kgf/cm?, psi)]490.33(5.0, 71.12) Internal resistance(?)10~11
...