Accelerator Position Sensor (APS) is installed on the
accelerator pedal module and detects the rotation angle of the
accelerator pedal. The APS is one of the most important sensors in
engine control system, so it consists of the two sensors which adapt
individual sensor power and ground line. The second sensor monitors the
first sensor and its output voltage is half of the first one. If the
ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the
diagnostic system judges that it is abnormal.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector.
3.
Remove the OTS. (Refer to "Removal")
4.
After immersing the thermistor of the sensor into engine coolant ...
Specification
AcceleratorPositionOutput Voltage (V)APS1APS2C.T0.7 ~ 0.80.29 ~ 0.46W.O.T3.85 ~ 4.351.93 ~ 2.18
...
See also:
GVWR (Gross vehicle weight rating)
This is the maximum allowable weight of the fully loaded vehicle (including all
options, equipment, passengers and cargo). The GVWR is shown on the certification
label located on the driver’s (or fr ...
Repair procedures
Adjustment
Inspect Glass Alignment
1.
Check for abnormal noise or bending during operation.
2.
With the sunroof fully closed, check for water leakage.
3.
The roof panel (B) should be even ...
Intake Actuator Components and Components Location
Component Location
...