Removal |
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
To remove the seat belt anchor pretensioner (C), keep on
pushing the lock pin (A) as arrow direction. And then remove the seat
belt after pushing the lock pin (B). |
3. |
Remove the door scuff trim.
|
4. |
Remove the center pillar trim.
|
5. |
Disconnect the anchor pretensioner connector (A). |
6. |
Loosen the anchor pretensioner mounting bolt (B) and remove the anchor pretensioner. |
Installation |
1. |
Remove ignition key from the vehicle. |
2. |
Disconnect the negative (-) cable from battery and wait for at least three minutes. |
3. |
Install the anchor pretensioner with a bolt.
|
4. |
Connect the anchor pretensioner connector. |
5. |
Install the center pillar trim.
|
6. |
Install the door scuff trim.
|
7. |
Insert the seat belt to the anchor pretensioner (A).
|
8. |
Reconnect the battery negative cable. |
9. |
After installing the anchor pretensioner, confirm proper system operation:
|
Input Speed Sensor Specifications
Specifications
? Type: Hall effect sensor
Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.95~1.65)0.037~0.065Output voltage(V)High1.18~1.68Low0.59~0.84
...
Rear Door Window Glass Components and Components Location
Component Location
1. Rear door window glass
...
Overhead Console Lamp Repair procedures
Inspection
Overhead Console Lamp
Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
...