Hyundai Azera: BJ Boot Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures
| Replacement |
| 1. |
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
| 2. |
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”) |
| 3. |
Remove the dynamic damper.
(Refer to Driveshaft Assembly - "Dynamic Damper") |
| 4. |
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).
|
| 5. |
Remove the BJ boot. |
| 6. |
Install in the reverse order of removal.
|
BJ Boot Components and Components Location
Components
[LH]
1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circl ...
See also:
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the e ...
Tire traction
Tire traction can be reduced if you drive on worn tires, tires that are improperly
inflated or on slippery road surfaces. Tires should be replaced when tread wear
indicators appear. To reduce the po ...
Components and Components Location
Components
1. Rear door trim2. Rear door inside handle cap3. Rear door module4. Rear frame inner cover5. Rear door panel6. Rear door delta lower run & channel7. Rear door frame rear garnish8 ...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com