Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the lower crash pad.
|
3. |
Disconnect the stop lamp switch connector (A). |
4. |
Pull the locking plate (A) as indicated by the arrow. |
5. |
Turn stop lamp switch 45° counterclockwise and remove it. |
Installation |
1. |
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part. |
2. |
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing. |
3. |
Confirm the gap between stop lamp switch and bracket.
|
4. |
Connect the stop lamp switch connector.
|
5. |
Install the lower crash pad.
(Refer to the Body - "Crash Pad") |
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Recommended SAE viscosity number
Always be sure to clean the area around any filler plug, drain plug, or dipstick
before checking or draining any lubricant. This is especially important in dusty
or sandy areas and when the vehicle ...
Components and Components Location
Components Location
1. AVN (A/V & Navigation head unit)2. Midrange speaker3. External amplifier4. Glass antenna (Radio)5. Front door speaker6. Rear door speaker7. Subwoofer speaker8. Antenna ...