Removal |
[RH] |
1. |
Remove the RH bank timing chain.
(Refer to Timing System - "Timing Chain") |
2. |
Remove the RH exhaust CVVT oil control valve.
|
3. |
Remove the RH camshaft bearing cap (A) and thrust bearing cap (B). |
4. |
Remove the RH intake camshaft (A) and exhaust camshaft (B) |
[LH] |
1. |
Remove the RH/LH timing chain.
(Refer to Timing System - "Timing Chain") |
2. |
Remove the LH exhaust CVVT oil control valve.
|
3. |
Remove the fuel pump bracket (A) |
4. |
Remove the LH camshaft bearing cap (A) and thrust bearing cap (B). |
5. |
Remove the LH intake camshaft (A) and exhaust camshaft (B) |
Installation |
|
[RH] |
1. |
Install the RH intake camshaft (A) and exhaust camshaft (B)
RH Inkate camshaft
As for camshaft identification, refer to the table below.
RH Exhaust camshaft
As for camshaft identification, refer to the table below.
|
2. |
Install the bearing cap (A) and thrust bearing cap (B) with specified torque.
A : L(LH),R(RH)
B : I(Intake), None(Exhaust)
C : Journal number
D : Front mark
|
3. |
Install the other parts reverse order of removal. |
[LH] |
1. |
Install the LH intake camshaft (A) and exhaust camshaft (B)
LH Inkate camshaft
As for camshaft identification, refer to the table below.
LH Exhaust camshaft
As for camshaft identification, refer to the table below.
|
2. |
Install the bearing cap (A) and thrust bearing cap (B) with specified torque.
A : L(LH),R(RH)
B : I(Intake), None(Exhaust)
C : Journal number
D : Front mark
|
3. |
Install the fuel pump bracket (A)
|
4. |
Install the other parts reverse order of removal. |
Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the
evaporative emission control system and is installed on the fuel tank,
the fuel pump, or the canister. It checks the purge con ...
Searching Radio Frequencies
Using Seek
Press the key to play the previous/next
frequency.
Using TUNE
Turn the ,
keys to select the frequency.
FM : Increases/decreased by 200kHz
AM : Increases/decreased by 10kHz
...
Main Muffler Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
(Refer to Engine Electrical System - "Battery")
2.
Remove the main muffler (A).
Tightening torque:
39.2 ~ 58.8 N.m ( ...