Hyundai Azera: Cluster Fascia Panel Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	Using a screwdriver or remover, remove the crash pad side cover (A).

2.	Using a screwdriver or remover, remove the fuse box cover (A).

3.	After loosening the mounting screws, then remove the crash pad lower panel (A).

4.	Disconnect the diagnosis connector (A) and connector (B).

5.	After loosening the mounting screws, then remove the crash pad garnish [LH] (A).

6.	After loosening the mounting screws, then remove the cluster fascia panel (A).

7.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Cluster Fascia Panel Components and Components Location

Component Location 1. Cluster fascia panel ...

Center Fascia Panel Components and Components Location

Component Location 1. Center fascia panel ...

See also:

Front Stabilizer Bar Repair procedures
Replacement 1. Remove the front wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) • Be careful not to damage to the hub b ...

Front Washer Motor Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for ...

Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels ali ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com