Crankshaft Position Sensor (CKPS) detects the crankshaft
position and is one of the most important sensors of the engine control
system. If there is no CKPS signal input, the engine may stop because of
CKPS signal missing. This sensor is installed on the cylinder block or
the transaxle housing and generates alternating current by magnetic flux
field which is made by the sensor and the target wheel when engine
runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA (Crank Angle).
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the ECTS connector.
3.
Remove the ECTS (Refer to "Removal").
4.
After immersing the thermistor of the sensor into engine coola ...
Specification
ItemSpecificationCoil Resistance (?)774 ~ 946 [20°C(68°F)]Air Gap (mm)0.5 ~ 1.5
...
See also:
Components and Components Location
Components
1. Telemetics Unit (TMU)2. AVN or Audio Head Unit3. Room Mirror Switch (Blue Link button, Center button, SOS button)4. Mic5. Roof Antenna (GPS+CDMA)
...
Trunk room lamp
The trunk room lamp comes on for 20 minutes when the trunk is opened. ...
Cowl Top Cover Repair procedures
Replacement
1.
Remove the cap (B) and remove the nuts, then remove the wiper arm (A).
Tightening torque :
22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 lb-ft)
2.
Disconnect the nozzle hose (B). ...