Hyundai Azera: Crankshaft Position Sensor (CKPS) Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check the signal waveform of the CMPS and CKPS using the GDS.

Specification: Refer to “Wave Form”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Disconnect the crankshaft position sensor connector (A).

4.	Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage when installation.

Installation is reverse of removal.

Crankshaft position sensor installation bolt:

6.9 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.1 ~ 7.2 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic Diagrams

Circuit Diagram ...

Camshaft Position Sensor (CMPS) Description and Operation

Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Hyundai Azera: Crankshaft Position Sensor (CKPS) Repair procedures

Crankshaft Position Sensor (CKPS) Schematic Diagrams

Camshaft Position Sensor (CMPS) Description and Operation

See also:

Categories

Hyundai Azera Manuals