Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the OTS connector. |
3. |
Remove the OTS. (Refer to "Removal") |
4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2. |
5. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the air cleaner assembly.
|
3. |
Disconnect the connector (A), and then remove the CVVT oil temperature sensor (B). |
Installation |
|
|
|
1. |
Installation is reverse of removal.
|
Components and Components Location
Component Location
1. Start Stop Button(SSB)2. FOB key3. Smart key unit4. RF receiver5. Interior antenna 16. Interior antenna 2 7. Trunk antenna8. Door handle & ...
Line Pressure Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Specifications
Direct control VFS[T/CON]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)] 9.81~ 500.14 (0.1~ 5.1, 1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal res ...