Ignition timing is controlled by the electronic control
ignition timing system. The standard reference ignition timing data for
the engine operating conditions are preprogrammed in the memory of the
ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up
condition, etc.) are detected by the various sensors. Based on these
sensor signals and the ignition timing data, signals to interrupt the
primary current are sent to the ECM. The ignition coil is activated, and
timing is controlled.
On-vehicle Inspection
Spark Test
1.
Remove the ignition coils.
(Refer to Ignition System - "Ignition Coil")
2.
Using a spark plug socket, remove the spark plug.
3.
Install the spark p ...
See also:
Main Crash Pad Assembly Components and Components Location
Component Location
1. Main crash pad assembly
...
General Information
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before starting work.
The support rod must be inserted into the ...
Rear Body Body Repair
Roof panel rear cornerSide outer panel rear cornerRear package tray trim mounting hole (O12) Side outer panel rear cornerRear combination lamp mounting hole(8.5X8.5) Rear bumper mounting hole (14X ...