Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim panel.
|
3. |
Remove the connector(A) and door LED mood lamp(B).
|
4. |
Remove the rear door trim panel.
|
5. |
Remove the connector and door LED mood lamp(A).
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim panel.
|
3. |
Remove the rear door trim panel.
|
4. |
Replace the door lamp bulb with turning the socket counterclockwise.
[Front Door]
[Rear Door] |
Installation |
Mood Lamp |
1. |
Install the door mood lamp and connector. |
2. |
Install the door trim. |
3. |
Connect the negative (-) battery terminal. |
Door Lamp |
1. |
Install the door lamp and connector. |
2. |
Install the door trim. |
3. |
Connect the negative (-) battery terminal. |
SS-A Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Input Speed Sensor Specifications
Specifications
? Type: Hall effect sensor
Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.95~1.65)0.037~0.065Output voltage(V)High1.18~1.68Low0.59~0.84
...
Description and Operation
Description
•
EPS (Electric power steering, Column assist type) system uses
an electric motor to assist the steering force and it is an engine
operation independent steering system.
• ...