Replacement |
1. |
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
2. |
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”) |
3. |
Using a pillar or flat-tipped(-) screwdriver, remove the both side of clamp(B) of the dynamic damper(A). |
4. |
Fix the driveshaft (A) with a vice (B) as illustrated. |
5. |
Apply soap powder on the shaft to prevent being damaged
between the shaft spline and the dynamic damper when the dynamic damper
is removed. |
6. |
Seperate the dynamic damper (A) from the shaft (B) carefully. |
Installation |
1. |
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. |
2. |
Install the dynamic damper (A). |
3. |
Using the SST(09495-3K000), secure the dynamic damper bands (B). |
4. |
Install the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”) |
5. |
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
Repair procedures
Removal
Front View Camera
1.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
2.
Loosen 3 screws and disconnect the connector(6 pins). Remove the front view camera(A).
Back ...
Rear Shock Absorber Repair procedures
Replacement
1.
Remove the rear wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolts w ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Schematic Diagrams
Circuit Diagram
...