Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the ECTS connector. |
3. |
Remove the ECTS (Refer to "Removal"). |
4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. |
5. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the air cleaner assembly.
|
3. |
Disconnect the engine coolant temperature sensor connector (A). |
4. |
Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.
|
5. |
Supplement the engine coolant.
|
Installation |
|
|
|
1. |
Installation is reverse of removal.
|
Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory
to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels ali ...
Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON'T remove the camshaft position se ...
Starting the engine
WARNING - Proper footwear
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots, sandals, etc.) may interfere with your ability to use the
brake and acc ...