Removal |
1. |
Turn the ignition switch OFF. |
2. |
Remove the air duct (B) and air cleaner assembly (A). |
3. |
Remove the connector and then arrange the wiring harness (A). |
4. |
Remove the brake fluid from the master cylinder reservoir with a syringe.
|
5. |
Loosen the flare nuts and then remove the brake tube (A).
|
6. |
Pull up the lock of the HECU connector (A) and then disconnect the connector. |
7. |
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.
|
8. |
Loosen the HECU bracket bolts (A) and then remove HECU and bracket.
|
9. |
Remove the bolts and then remove the bracket from HECU.
|
Installation |
1. |
Installation is the reverse of removal. |
2. |
Tighten the HECU mounting bolts and nuts to the specified torque. |
3. |
After installation, bleed the brake system.
(Refer to Brake system - "Bleeding") |
Exhaust pipe and muffler
Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration,
or damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten
connections or replace parts ...
Front Wheel Speed Sensor Components and Components Location
Components
1. Front wheel speed sensor2. Front wheel speed sensor connector
...
Knock Sensor (KS) Description and Operation
Description
Knocking is a phenomenon characterized by undesirable
vibration and noise and can cause engine damage. The two Knock Sensor
(KS) are installed inside the V-valley of the cylinder bl ...