Hyundai Equus Manuals

Hyundai Azera: ESCL(Electronic Steering Column Lock) Repair procedures - Button Engine Start System - Body Electrical System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: ESCL(Electronic Steering Column Lock) Repair procedures

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel.
3.
Remove the steering column upper and lower shrouds.
4.
Disconnect the electronic steering column lock connector (A).

5.
Remove the electronic steering column lock after removing the shear bolts.
   
Using a suitable tool, cut slots into the heads of the shear bolts.
Wear safety glasses to protect your eyes from flying bits of metal.
Wear work gloves to protect your hands from any sharp metal edges on the shear bolt.
Installation
1.
Install the electronic steering column lock (A).
   
Do not reuse the shear bolts.
When installing the new shear bolts to the electronic steering column lock, tighten the shear bolts until its head is cut off.

Tightening torque :
7 ~ 13 N.m (0.7 ~ 1.3 kgf.m, 5 ~ 9.4 lb.ft)

2.
Install the steering column.
3.
Install the crash pad lower panel.
ESCL(Electronic Steering Column Lock) Components and Components Location
Component ...

Front / Rear Parking Assist System
...

See also:

In-car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals. 1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...

Troubleshooting
Failure Diagnosis 1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is prohibited. 3. However, when the ...

Repair procedures
Compression Pressure Inspection     If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up engine until th ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com